********************************************************
*						       *
*						       *
*    BusLogic Windows NT SCSI Driver  version 1.20     * 
*						       *
*						       *
********************************************************


Introduction
------------

   This BusLogic driver update enhances the Microsoft-shipped BusLogic
   Windows NT SCSI driver by providing support for up to 15 SCSI targets 
   or devices (Wide SCSI support) and PCI-compliant support for BusLogic 
   BT-946C PCI compliant host adapters.


Installation on WIN/NT v3.5
---------------------------

   Before installing this BusLogic Windows NT 3.5 SCSI Driver, you should
   fully install Windows NT 3.5. Windows NT 3.5 comes bundled with a copy
   of the BusLogic SCSI driver - this driver will be used throughout 
   installation.
   Once NT is installed and you have rebooted NT from the hard disk following
   the installation, you can install the BusLogic driver update in the 
   following manner:

	1) Copy the BusLogic file A:\WINNT35\BUSLOGIC.SYS from the BusLogic
	   diskette over to the \<Root>\SYSTEM32\DRIVERS directory on the 
	   Win/NT boot drive (usually C:). <Root> is, by default, "WINNT35"
	   under NT 3.5.Replace <Root> in the destination path with either
	   the  default or, if overriden, whatever directory was specified
	   during NT installation.

	2) Reboot the Windows NT system to invoke the new BusLogic driver.


To reach us & the latest drivers and information:

Tech Support:   (408) 654-0760
FAX:            (408) 492-1542
BBS:            (408) 492-1984
Email:          techsup@buslogic.com
FTP Site:       ftp.buslogic.com (204.160.180.11)
WWW Page:       http://www.buslogic.com