Fujitsu M2694EHA:Switch Settings

PCA Layout  All configurations marked * are default settings.

Switch SW1

SCSI Level
   Key 1   ON*   SCSI-1/CCS Mode
           OFF   SCSI-2 Mode
Off-Line Self-Diagnostics
   Key 2   ON    Executed (diagnostic mode)
           OFF*  Inhibited (normal operation)
UNIT ATTENTION response
   Key 3   ON*   Reports the CHECK CONDITION status
           OFF   Does not report CHECK CONDITION
Reselection Retry Count
   Key 4   ON*   Unlimited
           OFF   10 times
SCSI Bus Parity
   Key 5   ON*   Enabled
           OFF   Disabled
Synchronous Data Transfer Request
   Key 6   ON*   Enabled from TARG
           OFF   Disabled from TARG
LED Display Requirement
   Key 7   ON*   LED activated when drive seeking
           OFF   LED activated when drive idle
Motor Start Mode
   Key 8   ON*   On Power Up
           OFF   Via START/STOP UNIT Command

Terminal CNH2

Terminal CNH10

    1-2  SHORT*   Do not change.

    SCSI Terminating Power
    3-4  SHORT*   Power is supplied to the SCSI circuitry from the IDD.
         OPEN     Power is not supplied to the SCSI circuitry.

Terminal CNH11

Set SCSI ID
     5-6     3-4     1-2    ID
    OPEN*   OPEN*   OPEN*    0
    OPEN    OPEN    SHORT    1
    OPEN    SHORT   OPEN     2
    OPEN    SHORT   SHORT    3
    SHORT   OPEN    OPEN     4
    SHORT   OPEN    SHORT    5
    SHORT   SHORT   OPEN     6
    SHORT   SHORT   SHORT    7
Write Protection
    7-8  SHORT*   Disabled
         OPEN     Enabled
   9-10  OPEN*    Reserved

Connector CN7

Spindle synchronisation connection
     Pin   Signal
      01   GND IN
      02   SpSync IN
      03   GND OUT
      04   SpSync OUT

Connector CN5

External LED connection
     Pin   Signal
      01   LED(V)
      02   LED

Connector CN6

External SCSI ID connector
     Pin   Signal
      01   GND
      02   -ID2 (bit 4)
      03   GND
      04   -ID1 (bit 2)
      05   GND
      06   -ID0 (bit 1)

to the table of contents!!