Fujitsu M2615/M2616S/M2616ESA/M2616ESB:Switch Setting

PCA Layout All configurations marked "*"are default settings

Setting Plugs CNH1

SCSI Bus Parity
    1-2(*)  SCSI bus parity is enabled.
    2-3     SCSI bus parity is disabled.

Synchronous transfer mode
    4-5(*)  Synchronous transfer is enabled.
    6-7     Synchronous transfer is disabled.

SCSI terminator power
    7-8 10-11  1)SCSI bus terminator power source is used.(*)
               2)IDD terminator power source is used.(note)
    8-9 10-11  IDD terminator power source is used.
    7-8  9-10  SCSI bus terminator power source is used.
   (note)
    According to the following condition, power source for terminator is
    decided.
    1)Bus terminator power voltage higher to IDD power voltage
    2)Bus terminator power voltage lower to IDD power voltage
    (IDD terminator power voltage equal to IDD power voltage : 5.0V-0.3V=4.7V)

Setting Plugs CNH2

SCSI ID
      CNH2     SCSI ID
   2-3 5-6 8-9    0
   1-2 5-6 8-9    1
   2-3 4-5 8-9    2
   1-2 4-5 8-9    3
   2-3 5-6 7-8    4
   1-2 5-6 7-8    5
   2-3 4-5 7-8    6
   1-2 4-5 7-8    7

Dip Switch Settings

Write protect
   Key 1   ON      Write protect
           OFF(*)  Non write protect
Motor control
   Key 2   ON(*)   Self-starting
           OFF     Waiting MOTOR START command
Self-diagnostic mode
   Key 3   ON      Normal mode
           OFF(*)  Test mode

to the table of contents!!