Fujitsu M1603T/M1606T:Switch Settings

PCA Layout  All configurations marked "*" are default settings

Setting Terminals

Terminal CNH1

        Pins    Status     Function
        1-2     SHORT(*)   Set drive as MASTER
                OPEN       Set drive as SLAVE
        3-4     SHORT      ACMODE connected to the interface
                OPEN(*)    ACMODE disconnected from interface
                           ACMODE is a special feature which allows
                           the system to tell the drive whether or not the
                           drives own power save functions take priority
                           over any power commands issued by the system.
                           This function is assigned to pin 28 of the
                           interface when these pins are shorted. This
                           function should not be used unless you are certain
                           that your system supports this feature.
        5-6     SHORT(*)   Disable auto idle control
                OPEN       Enable auto idle control
        7-8     SHORT      CSEL connected to the interface
                OPEN(*)    CSEL not connected to interface
                           CSEL disconnected from interfaceCable select
                           mode gives an alternative method by which the
                           drive may be set to MASTER or SLAVE. A special
                           cable is needed to implement this feature and
                           should only be used if supported by both drives.
                           CSEL should only be used in conjunction with
                           SLAVE and without ACMODE.
        9-10    OPEN       Reserved

Connector CN5

External LED connector
         Pin     Function
         01      LED(V)
         02      LED
 (notes)  Cable length should not exceed 30 centimetres.

to the table of contents!!