CFP2107S Customer options

CFP2107S
Customer options

SCSI Bus Address
There are three jumpers available for configuration of SCSI ID: E1, E2, and E3. The following table defines the settings:

(The table on this page requires NETSCAPE version 1.1 or later for proper viewing.)

SCSI Bus Addresses*

E1 E2 E3 SCSI ID

OUT OUT OUT O

IN OUT OUT 1

OUT IN OUT 2

IN IN OUT 3

OUT OUT IN 4

IN OUT IN 5

OUT IN IN 6

IN IN IN 7

SCSI Bus Addresses*
E1	E2	E3	SCSI ID
OUT	OUT	OUT	O
IN	OUT	OUT	1
OUT	IN	OUT	2
IN	IN	OUT	3
OUT	OUT	IN	4
IN	OUT	IN	5
OUT	IN	IN	6
IN	IN	IN	7

*Use either but not both : E1 to E3 or 0E1 to 0E3. The 0E header is not installed on drive configurations with a LED on the PCBA.
Disable Spin: A jumper in the E5 location, disables spin up on power-on. Disabling spin up on application of power can also be enabled by settting the DSPN bit in MODE SELECT page 00H.

J4

1 +12 V

2 Ground

3 Ground

4 +5V

J4
1	+12 V
2	Ground
3	Ground
4	+5V

Mounting Holes

Side: 6-32 UNC-2B .15 Max. Insertion

Bottom: 6-32 UNC-2B .25Max. Insertion

Mounting Holes
Side: 6-32 UNC-2B .15 Max. Insertion
Bottom: 6-32 UNC-2B .25Max. Insertion