CFP1060S
Customer Options

There are three jumpers available for configuration of SCSI ID: E1, E2, and E3. The following table defines the settings:

SCSI Bus Addresses*

(The table on this page requires NETSCAPE version 1.1 or later for proper viewing.)

E1/OE1 E2/OE2 E3/OE3 SCSI ID
OUT OUT OUT 0
IN OUT OUT 1
OUT IN OUT 2
IN IN OUT 3
OUT OUT IN 4
IN OUT IN 5
OUT IN IN 6
IN IN IN 7

*Use either but not both : E1 to E3 or 0E1 to 0E3. The 0E header is not installed on drive configurations with a LED on the PCBA.
Disable Spin: A jumper in the E5 or 0E5 location, disables spin up on power-on. Disabling spin up on application of power can also be enabled by settting the DSPN bit in MODE SELECT page 0.

E4 Reserved
E5/OE5 Disable Spin on Power-on
E6 Spin Delay by SCSI ID
E7 Disable SCSI Bus Parity

cfp

J4
1 +12V
2 Ground
3 Ground
4 +5V

Mounting Holes
Side: 6-32 UNC-2B .15 Max. Insertion
Bottom: 6-32 UNC-2B .25 Max. Insertion