+-----------------------------------------------------+
          | ICD1200/AT Support Software Version 1.0 Information |
          +-----------------------------------------------------+

This document describes information of ICD1200/AT Support Software.
Prior to use the unit, be sure to read this information with the
User's guide.
         +--------------------+
         | About Installation |
         +--------------------+

(1) This installar (INSTALL.EXE) changes CONFIG.SYS and AUTOEXEC.BAT
    as follows and registrates a device driver (IMES_CD.SYS).

    (CONFIG.SYS)
         DEVICE = C:�_IMES_CD.SYS /D:IMESCD01

    (AUTOEXEC.BAT)
         C:�_MSCDEX.EXE /D:IMESCD01

    Note: The device name /D:IMESCD01 in CONFIG.SYS and AUTOESEC.BAT
          must be same.

(2) Install to PC-DOS and Windows 3.1
    1.Activate PC-DOS
    2.Insert the Option Diskette in the package into a drive A.
    3.Key in A:INSTALL and execute.
    4.Follow the instructions on the screen.

(3) Install to Windows 95
    As in Windows 95 a deveice driver is installed as a base function,
    this installer may not be installed specifically.
    But with the device driver in Windows 95 does not support CD-I,
    CD-G and DMA data transfer.
    The device driver supllied with ICD1200/AT support CD-I, CD-G
    and DMA.

    How to install to Windows 95
    ----------------------------
    1.Actuate PC in DOS mode of Windows 95.
         -Click START
         -Click EXIT FROM Windows
         -Click RETURN TO MS-DOS MODE
    2.Insert the Option Diskette in the package into a drive A.
    3.Key in A:INSTALL and execute.
    4.Follow the instructions on the screen.
    5.Reset PC (key in ctrl+alt+delete at same time)
    6.On the Windows screen
         -Click START
         -Click CONTROL PANEL
         -Click SYSTEM
         -Click PERFORMANCE
         -Click FILESYSTEM
         -Click TROUBLE SHOOTING
         -Click DO NOT USE DISK DREIVE WITH 32BITS PROTECT MODE
         -Click O.K
         -Click CLOSE BUTTON (X mark)


    Set the DMA data transfer
    -------------------------
    Add /BMO to DEVICE = C:�_IMES_CD.SYS /D:IMESCD01 
      (Example) DEVICE = C:�_IMES_CD.SYS /D:IMESCD01 /BMO

    Note: Prior setting DMA, make sure your PC supports DMA. If you are not
          sure, contact the PC supplier.